What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 18.06.2025 05:19

It also is a device that limits the change in current flow.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
(Dc diagram shown, AC is similar).
He then describes the function of a fuse.
The other is “what does a “fuse” do?”
What are examples of real life forced feminization?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Here is a simplified AC power diagram.
But it can get overloaded, and no longer works.
nine
Because the load is inductive, the current lags the voltage.(by a bit).
I’m running away I live in Indiana what states near by are safe I’m 12 no comments?
This is where this question deviates from being a 'generic' question, and becomes more specific.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
How can I handle my distrust and jealousy for my partner?
First Sentence:
A fuse is a non-resetable over current circuit protector.
I post the exact comment here.
The bolt then partially travels down the line to your home.
What is lightning?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
States With the Most Generous Tippers - Newser
what exactly is a ‘surge’ protector?
Now when you have a certain ac resistance, then a current flows in a loop.
This is where the MOV conducts again, and dissipated the energy.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
[image of Common-mode choke]
He then asserts :
Do you as a gay male enjoy the feeling of getting a penis in your anus?
eight
For this case there are devices called Metal oxide varistors (MOV).
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Have you ever been physically attacked by a demon?
He then describes Rainy Season and Lightning.
These devices are installed between the “hot” and “neutral” and protective ground.
What does a fuse do?
What do you typically do while on meth?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
So, the voltage could go up to 500 volts, and the fuse will not open up.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One is “what exactly is in a ‘surge protector’ ? ”
There are three different concepts here that are getting confused.
There are two important concepts here.
The MOV will conduct when the voltage exceeds 50% of line voltage.
but I think this circuit , shows a few more pieces.
This is 'the assistant's answer'
2024–10–16 [ OO OLAOYE OYEBODE ]
In schematic diagrams this is the symbol for a fuse:
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
the problem then depends on "how fast does the fuse operate?".
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These are simplified answers to the original question, and does not change anything I wrote above.
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
It seems Mohan does not understand the difference between a comment and an Answer.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Barnstars:
The third is lightning and “how it gets conducted into a home.”
Upvotes:
2024–10–14 [Omar Gharbi Omar Gharbi ]
But… the neutral is now “floating” because of the 1 ohm resistance.
so, what happens?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
An AC voltage/ current source, and an ac inductive load.
a photo is worth a thousand words.
Edit 2024–10.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
[old diagram got deleted by accident]
This one hit behind the barn.
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–10[John johnson John Johnson ]
A circuit breaker is similar, but is resettable.
At least they know the answer if they wanted it.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
One
This device then solves the entire problem.